Ip Telnet Server Vrf - Dell S6000 Reference Manual

Version 9.0.2.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
Related ip ssh server
Commands

ip telnet server vrf

Configures the TELNET server on either a specific VRF or a management VRF.
Syntax
ip telnet server vrf {management | vrf-name}
To undo the TELNET server configuration, use the no ip telnet server [vrf
vrf-name] command.
Parameters
vrf
management
vrf vrf-name
Defaults Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.4.
(0.0)
Usage You can enable the TELNET server on either a management VRF or a user defined
Information VRF but not both. If you do not specify a VRF, then the TELNET server is enabled on
the default VRF.
Example
FTOS(conf)#ip telnet server vrf vrf1
FTOS(conf)#no ip telnet server vrf
Control and Monitoring
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enables the secure shell (SSH) server on the system.
Enter the keyword vrf followed by the keyword
management to specify a management VRF that is used by
the TELNET server.
Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TELNET server.
Introduced on the S-Series and Z-Series.
101