Ip Access-Group - Dell S6000 Reference Manual

Parameters
access-list-
name
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1

ip access-group

Assign an IP access list (IP ACL) to an interface.
S6000
Syntax
ip access-group access-list-name {in | out} [implicit-permit]
[vlan vlan-id] [vrf vrf-name]
To delete an IP access-group configuration, use the no ip access-group
access-list-name {in | out} [implicit-permit] [vlan vlan-id]
[vrf vrf-name] command.
Parameters
access-list-
name
in
out
implicit-permit
Access Control Lists (ACL)
(OPTIONAL) Enter the name of a configured access-list, up
to 140 characters.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increase the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the name of a configured access list, up to 140
characters.
Enter the keyword in to apply the ACL to incoming traffic.
Enter the keyword out to apply the ACL to outgoing traffic.
(OPTIONAL) Enter the keyword implicit-permit to
change the default action of the ACL from implicit-deny to
173