Dell S6000 Reference Manual page 57

Version 8.4.1.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series
Usage Dell Networking OS supports a maximum of 100 files at the root directory level, on
Information both the internal and external Flash.
When copying a file to a remote location (for example, using Secure Copy [SCP]),
enter only the keywords and Dell Networking OS prompts you need for the rest of
the information. For example, when using SCP, you can enter copy running-
config scp: where running-config is the source and the target is specified in
the ensuing prompts. Dell Networking OS prompts you to enter any required
information, as needed for the named destination—remote destination, destination
filename, user ID, password, etc.
When you use the copy running-config startup-config command to copy
the running configuration (the startup configuration file amended by any
configuration changes made since the system was started) to the startup
configuration file, Dell Networking OS creates a backup file on the internal flash of
the startup configuration.
Dell Networking OS supports copying the running-configuration to a TFTP server
or to an FTP server. For example:
•
•
You can compress the running configuration by grouping all the VLANs and the
physical interfaces with the same property. Support to store the operating
configuration to the startup config in the compressed mode and to perform an
image downgrade without any configuration loss are provided.
Two existing exec mode CLIs are enhanced to display and store the running
configuration in the compressed mode.
Example
Dell#copy running-config scp:/
Address or name of remote host []: 10.10.10.1
Destination file name [startup-config]? old_running
User name to login remote host? sburgess
Password to login remote host? dilling
File Management
Added IPv6 addressing support for FTP, TFTP, and SCP.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added usbflash and rpm0usbflash commands on E-
Series ExaScale.
Introduced on the S-Series and added the SSH port number
to the SCP prompt sequence on all systems.
Introduced on the C-Series.
Original command.
copy running-config tftp:
copy running-config ftp:
57