Dell S6000 Reference Manual page 48

To enter INTERFACE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the interface command and then enter an interface type and interface number that is
available on the switch.
The prompt changes to include the designated interface and slot/port number. For example:
Prompt Interface Type
Dell(conf-if)# INTERFACE mode
Gigabit Ethernet interface then the slot/port information
Dell(conf-if-
gi-0/0)#
Ten-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
te-0/0)#
Forty-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
fo-0/0)#
Loopback interface number
Dell(conf-if-
lo-0)#
Null Interface then zero
Dell(conf-if-
nu-0)#
Port-channel interface number
Dell(conf-if-
po-0)#
VLAN Interface then VLAN number (range 1–4094)
Dell(conf-if-
vl-0)#
Management Ethernet interface then slot/port information
Dell(conf-if-
ma-0/0)#
Tunnel interface then tunnel ID.
Dell(conf-if-
tu-0)#
Designated interface range (used for bulk configuration).
Dell(conf-if-
range)#
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use
the ip access-list standard or ip access-list extended command.
To enter IP ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the ip access-list standard or ip access-list extended command. Include a name
for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, refer to
Intermediate System to Intermediate System
48
(IS-IS).
CLI Basics