Seq - Dell S6000 Reference Manual

Usage
When you have exhausted all the sequence numbers, this feature permits re-
Information
assigning a new sequence number to entries of an existing access-list.

seq

Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
S6000
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host
ip-address}} [count [bytes]] [dscp value] [order] [fragments]
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
deny
permit
source
mask
any
host ip-address
count
bytes
dscp
order
fragments
Access Control Lists (ACL)
Enter a number from 0 to 4294967290.
Enter the keyword deny to configure a filter to drop packets
meeting this condition.
Enter the keyword permit to configure a filter to forward
packets meeting this criteria.
Enter an IP address in dotted decimal format of the network
from which the packet was received.
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address or hostname.
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword bytes to count bytes the
filter processes.
(OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
(OPTIONAL) Enter the keyword order to specify the QoS
order for the ACL entry. The range is from 0 to 254 (where 0
is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
Enter the keyword fragments to use ACLs to control packet
fragments.
183