Ip Telnet Source-Interface - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

FTOS(conf)#ip telnet server vrf management

FTOS(conf)#no ip telnet server vrf

ip telnet source-interface

Set an interface's IP address as the source address in outgoing packets for Telnet sessions.

ip telnet source-interface interface

To return to the default setting, use the no ip telnet source-interface

[interface] command.

The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Enter the following keywords and slot/port or number

information:

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

For a Port Channel, enter the keyword port-channel

then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

For a tunnel interface, enter the keyword tunnel.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Control and Monitoring