Dot1X Authentication (Configuration) - Dell S6000 Reference Manual

Command line for the system
Hide thumbs Also See for S6000:
Table of Contents

Advertisement

Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.4.2.1
Usage
The prerequisites for enabling MAB-only authentication on a port are:
Information
In MAB-only authentication mode, a port authenticates using the host MAC
address even though 802.1xauthentication is enabled. If the MAB-only
authentication fails, the host is placed in the guest VLAN (if configured).
To disable MAB-only authentication on a port, enter the no dot1x auth-type
mab-only command.
Related
dot1x mac-auth-bypass
Commands

dot1x authentication (Configuration)

Enable dot1x globally. Enable dot1x both globally and at the interface level.
S6000
Syntax
dot1x authentication
To disable dot1x on a globally, use the no dot1x authentication command.
Defaults
Disabled
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
152
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Enable 802.1X authentication globally on the switch and on the port (the dot1x
authentication command).
Enable MAC authentication bypass on the port (the dot1x mac-auth-bypass
command).
— Enable MAC authentication bypass.
802.1X

Advertisement

Table of Contents
loading

Table of Contents