Hitachi Compute Blade 2000 User Manual page 429

Setting hotspares
This section describes the procedure for setting hotspares (reserve disks).
Reserve disk consists of a Global hotspare

effective for all logical drives configured and a
dedicated hotspare effective for a specified
logical drive. Select one for your purpose.
Be sure to configure redundant disk arrays, RAID

1, 5, 6, or 10 before setting hotspares.
Install a hard disk in the logical drive consisting of

hard disks. Install an SSD in the logical drive
consisting of SSDs. You cannot set a disk as a
reserve disk different from those configured the
logical drive.
1 With the main menu displayed, click a hard disk for hotspare from the hard
disk list in the Logical View / Physical View pane.
The following screen appears:
Only a hard disk whose status is Unconfigured Good
(unused) can be selected.
2 To set the disk to Global hotspare, check Make Global HSP.
To set the disk to Dedicated hotspare, select a logical drive group from the
right pane for hotspare and then check Make Global HSP.
378