Hitachi Compute Blade 2000 User Manual page 451

55 Unable to communicate to EKMS. If you continue,
there will be a drive security key error and all
secure configurations will be marked as foreign.
Please check connection with the EKMS, reboot
the machine to retry the EKMS or press any key
to continue.
56 Unable to change security to EKMS as not able to
communicate to EKMS. If you continue, the drive
security will remain to existing security mode.
Please check connection with the EKMS, reboot
the machine to retry the EKMS or press any key
to continue
57 DKM existing key request failed; existing secure
configurations will be labeled foreign and will not
be accessible. Reboot server to retry.
58 DKM new key request failed; controller security
mode transition was not successful. Reboot
server to retry request, or press any key to
continue.
59 The native configuration is no longer supported
by the current controller settings. Please ensure
that correct controller, iButton or key vault is
being used. If you continue, the configuration will
be marked foreign and part of it may be imported
if possible. Press any key to continue.
60 The battery is currently discharged or
disconnected. Verify the connection and allow 30
minutes for charging. If the battery is properly
connected and it has not returned to operational
state after 30 minutes of charging, contact
Technical Support for additional assistance.
Press D to disable this warning (if your controller
does not have a battery).
The battery is currently discharged or
61
disconnected. VDs configured in write-back mode
will run in write-through mode to protect your
data, and will return to write-back policy when the
battery is operational. If VDs have not returned to
write-back mode after 30 minutes of charging
then Contact Technical support for additional
assistance. The following VD is affected: X. Press
any key to continue.
62 Two BBUs are connected to the adapter. This is
not a supported configuration. Battery and
caching operations are disabled. Remove one
BBU and reboot to restore battery and caching
operations. If dirty cache is lost in this boot, that
could have been because of dual battery
presence.
63 Firmware did not find valid NVDATA image.
Program valid NVDATA image and restart your
system. Press any key to continue.
64 IR to MR Migration failed. Press any key to
continue with MR defined NVDATA values
Message
400
Description
The native configuration is not supported by the
current disk array controller settings. When this
message is displayed, contact your reseller or call
maintenance personnel.
Cache backup module information is incorrect.
When this message is displayed, contact your
reseller or call maintenance personnel.
Valid setting files are not found. When this
message is displayed, contact your reseller or call
maintenance personnel.
Migration is not supported. When this message is
displayed, contact your reseller or call
maintenance personnel.