Hitachi Compute Blade 2000 User Manual page 454

 User account configuration
Set a user account to remotely operate server blades.
See User account configuration
(X55A1/X55A2/X55R3/X55S3/X55R4
configure the user account in the same way as standard server blades.
 LPAR manager boot settings
Configure the LPAR manager boot settings.
Select Server Operation in the upper tabs and then select LP Setup in the tree
menu on the left to display the following screen.
If you do not use LPAR manager, set OS Mode to Basic Mode, which is the Default
setting.
If you use LPAR manager, set it to LP Mode.
#
1 Refresh
2 OS Mode
3 LP Model
4 LP Firmware Version
5 Switch the LP Firmware
6 Reset
7 Modify
in Standard server blade settings
models) for how to set user accounts. You can
Item
Reloads the information.
Basic Mode: Select this not to use LPAR
manager.
LP Mode: Select this to use LPAR manager.
Displays the LP model string.
Bank0, Bank1: Displays LP firmware version of
each bank.
Active: shows the firmware bank currently
selected.
Alternate: shows the firmware bank not
currently selected.
When firmware exists, its version is shown.
When no firmware exists, N/A is shown.
Selects which bank (Bank0 or Bank1) is to be
used for next LP boot. Switching banks is
executed at the next power-on or reset.
Cancels the edited settings.
Validates the edited settings and moves to the
confirmation screen.
403
Description