Cable Connection For The System Console - Hitachi Compute Blade 2000 User Manual

Cable connection for the system console

If a device with the same IP address as that for the Baseboard Management
Controller (BMC) on the management module or server blade exists on the
network, a failure will occur on the system equipment when you connect the
management module to a network.
Complete a network configuration before connecting a cable to the management
module.
Connect with LAN cable
Both straight cable or cross cable are available for the LAN port for the system console.
Communication rate is automatically selected from 10, 100, or 1000 Mbps.
Connect the MGMT0 port of the management module in the rear of the system
equipment to your system console terminal using a LAN cable. When two management
modules are installed, connect to the management module with the Master light
emitting diode (MSR LED) that lights solid green. Prepare the LAN cable to connect to
the terminal by yourself.
NOTICE
LAN cable
432
System console
terminal
MSR