Hitachi Compute Blade 2000 User Manual page 482

When you connect the management module via HTTP,
Telnet, or SSH, see the following table about the default
setting of the management module at the shipment:
Item
IP address
Subnet mask
HTTP
SSH
Telnet
Prepare the following items for connection via serial port.

A terminal for the system console

A connecting cable for the serial port (RS-232C

cross cable D-SUB9 pin female-female connector)
Terminal software such as Hyper Terminal: available

for VT100 emulation
When you connect to the serial port of a management
module, see the following table about communication
parameter settings to the terminal software.
Communication parameter
Communication rate
Data
Parity
Stopbit
Flow control
The system Web console cannot be used via serial port.

Setting at the shipment
192.168.0.1
255.255.255.0
Enabled
Enabled
Enabled
Setting
9600bps
8 bit
None
1 bit
None
431