Setup Of Terminal Software - Hitachi CB 520H A1 User Manual

Item
- Specify FCoE for the Emulex adapter.
For details on how to specify these, see the Hitachi Compute Blade Emulex
Adapter User's Guide for Hardware.
Note:
• When using CB 520X B1 in a 4-blade SMP configuration, disable SAS
controller on the EFI setup menu.
• When using the server blades in the following table, change the EFI
settings as shown below.
If you do not change the settings, you might not be able to start the LPAR
manager.
CB 520X B1
CB 520X B2
CB 520X B3
CB 520H B3
CB 520H B4
Notes:
1
.

Setup of Terminal Software

We recommend using the latest version of Tera Term as terminal software for
the LPAR manager. (Other software might not be able to use F1 to F12 key,
PageUp and PageDown key)
Initial setup configurations of Tera Term are below.
1 Select Setup - Terminal to change the setting to those in the following
.
table.
5-4
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Target
Managemen Switch
t module module
Table 5-2 Server Blade and EFI settings
Server Blade
No
Yes
No
Yes
No
No
Yes
No
In a 1-blade or 2-blade SMP configuration, the LPAR manager can be started
even when MM Config Base is set to 2 GB. In a 4-blade SMP configuration, make
sure to change to 3 GB.
Setup of LPAR manager
Server
blade
PCI 64-bit Resource
IOEU
Allocation
Enable (default)
Disable
Enable (default)
Disable
Enable (default)
Enable (default)
Disable
Enable (default)
Console Reference
MM Config Base
2GB (default)
2GB (default)
3GB (default)
3GB (default)
3GB (default)
2GB (default)
2GB (default)
2GB (default)
1
1