Table of Contents
Advertisement
Display device setup
This server supports both VGA port and Display port 1.1a. Before connecting a display device to this server, review the
information below.
•
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output,
connect it to the server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased
display quality or a lag over the connection.
•
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter.
Passive type adapter—marked with the DP++ symbol—is not supported.
•
Display output modes:
◦
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—
screen mirroring mode.
◦
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To
enable dual display mode, install a compatible graphics card that supports this feature in the expansion slot.
Rear panel LEDs
Item
LED
1
Power supply
2
iLO status
3
iLO link
4
UID
Status
Definition
Solid green
The power supply is operating normally.
Off
One or more of the following conditions exists:
•
•
•
•
•
Solid green
Lined to network
Flashing green
Network active
Off
No network activity
Solid green
Network link
Off
No network link
Solid blue
Activated
Power is unavailable
Power supply failure
Power supply is in standby mode
Power supply error
The front I/O cable is disconnected.
Table Continued
Component identification
14
Advertisement
Table of Contents
