Ip Prefix List Commands - Dell Z9500 Command Reference Manual

permit

IP Prefix List Commands

When you create an access-list without any rule and then apply it to an interface, the ACL behavior
reflects implicit permit.
To configure or enable IP prefix lists, use these commands.
access-class
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name [ipv4 | ipv6]
To remove an ACL, use the no access-class access-list-name [ipv4 |
ipv6] command.
Parameters
access-list-
name
ipv4
ipv6
Defaults Not configured.
Command LINE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
Access Control Lists (ACL)
— configures a filter to forward packets.
Enter the name of a configured Standard ACL, up to 140
characters.
Enter the keyword ipv4 to configure an IPv4 access class.
Enter the keyword ipv6 to configure an IPv6 access class.
Description
Added the ipv4 and ipv6 parameters to the command.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000–ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
295