Match Origin - Dell Z9500 Command Reference Manual

Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
routers.
match route-type
match tag

match origin

To match routes based on the value found in the BGP path ORIGIN attribute, configure a filter.
Z9500
Syntax
match origin {egp | igp | incomplete}
To disable matching filter, use the no match origin {igp | egp |
incomplete} command.
Parameters
egp
314
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter the keyword egp to match routes originating outside
the AS.
Access Control Lists (ACL)