Sflow Collector - Dell S6100 Configuration Manual

sflow collector

Configure a collector device to which sFlow datagrams are forwarded.
Syntax sflow collector {ip-address | ipv6-address} agent-addr {ip-address | ipv6-
address} [number [max-datagram-size number]] | [max-datagram-size number] [vrf
management]
To delete a configured collector, use the no sflow collector {ip-address | ipv6-address}
agent-addr {ipv4-address | ipv6-address} [number [max-datagram-size number]] |
[max-datagram-size number] [vrf management] command.
Parameters
sflow collector ip-
address | ipv6-
address
agent-addr ip-
address | ipv6-
address
number
max-datagram-size
number
vrf management
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4.(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
Enter the IP address of the collector in dotted decimal format for IPv4 or x:x:x:x::x format
for IPv6.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Enter the keyword agent-addr followed by the sFlow agent IP address in dotted
decimal format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
(OPTIONAL) Enter the user datagram protocol (UDP) port number. The range is from 0
to 65535. The default is 6343.
(OPTIONAL) Enter the keyword max-datagram-size then the size number in bytes. The
range is from 400 to 1500. The default is 1400.
(OPTIONAL) Enter the keyword vrf followed by the keyword management to configure
the collector device corresponding to the default VRF and the management VRF
respectively.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Added support for VRF.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
sFlow 1483