Dell S4810 Reference Manual page 89

flash:
A: | B:
stack-unit:
file-url
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.0(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Usage
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI)
Information
must be enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility this
command accepts IPv6 host addresses with or without the square brackets.
File Management
After entering the keyword flash:, you can either follow it
with the location of the source file in this form: flash//
filepath or press Enter to launch a prompt sequence.
Enter the partition to upgrade from the flash.
Enter the keywords stack-unit: to synch the image to the
stack-unit.
Enter the following location keywords and information to
upgrade using an Dell Networking OS image other than the
one currently running:
• To specify an Dell Networking OS image on the internal
flash, enter flash:// file-path/filename.
• To specify an Dell Networking OS image on an FTP
server, enter ftp://user:password@hostip/
filepath.
• To specify an Dell Networking OS image on the external
flash on the primary RPM, enter slot0://file-path/
filename.
• To copy a file on a TFTP server, enter tftp://hostip/
filepath/filename.
where hostip is either an IPv4 dotted decimal address or an
IPv6 URI [x:x:x:x::x] format address.
Added support for IPv6 for the file-url parameter.
Introduced on the S4820T.
Introduced on the Z9000. Added support for the SSD on the
Z9000 only.
Introduced on the S4810.
Added support for TFTP and SCP.
Introduced on the S-Series.
89