Dell S4810 Reference Manual page 73

Hide thumbs Also See for S4810:

Table of Contents

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.5(0.1)

Version 9.0.2.0

Version 9.0.0.0

Restoring factory defaults deletes the existing startup configuration and all

persistent settings (stacking, fan-out, and so forth).

When restoring all units in a stack, all the units in the stack are placed into stand-

When restoring a single unit in a stack, that unit placed in stand-alone mode. No

other units in the stack are affected.

When restoring units in stand-alone mode, the units remain in stand-alone mode

after the restoration. After the restore is complete, the units power cycle

immediately.

Following are the factory-default environment variables:

File Management

Enter the stack member unit identifier to restore only the

mentioned stack-unit.

Enter the keyword all to restore all units in the stack.

Enter the keyword bootvar to reset boot line.

Enter the keywords clear-all to reset the NvRAM, boot

environment variables, and the system startup configuration.

Enter the keyword nvram to reset the NvRAM only.

Added bootvar as a new parameters.

Introduced on the S6000.

Introduced on the Z9000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the MXL 10/40GbE Switch IO Module.

CAUTION: There is no undo for this command.

primary_boot