Display Vrrp Statistics - H3C s3600 series Command Manual

Table 1-2 Description on the fields of the display vrrp verbose command
Field
Run Method
Virtual Ip Ping
Interface
VRID
Adver. Timer
Admin Status
State
Config Pri
Run Pri
Preempt Mode
Delay Time
Auth Type
Virtual IP
Virtual MAC
Master IP

display vrrp statistics

Syntax
display vrrp statistics [ interface vlan-interface vlan-id [ vrid virtual-router-id ] ]
View
Any view
Parameters
vlan-interface vlan-id: Specifies a VLAN interface by its VLAN ID. vlan-id is the ID of the VLAN
interface.
vrid virtual-router-id: Specifies a VRRP group. virtual-router-id is the VRRP group ID, ranging from 1 to
255.
Description
Use the display vrrp statistics command to display the VRRP statistics information of VRRP group(s).
Refer to Table 1-3
If neither a VLAN interface nor a VRRP group is specified, the statistics information about all the
VRRP groups on the switch is displayed.
Current VRRP running method, including REAL-MAC and
VIRTUAL-MAC
Whether you can ping the virtual IP address of the VRRP group
Interface where the VRRP group resides
VRRP group ID
Interval for sending VRRP advertisements
Administrative state: UP or DOWN
Status of the current switch in the VRRP group, including Master,
Backup and Initialize
Configured priority
Running priority
Preemptive mode
Preemption delay
Authentication type, including NONE, SIMPLE, and MD5
Virtual IP address of the VRRP group
Virtual MAC address corresponding to the virtual IP address of the
VRRP group. It is displayed only when the switch is in the state of
master.
Primary IP address of the master's interface where the VRRP group
is configured.
for the displayed information.
Description
1-3