Monitoring Interface Tables; Configuring Traps - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide
show snmp interfaces

Configuring Traps

156
When the IfIndex and IfNumber maximums are reached, the system logs the event
and ignores the creation of additional interfaces, which means that new interfaces are
not visible in the interface table.
Example
host1(config)#snmp-server interfaces rfc1213 55000 100000
WARNING: Execution of this command will cause all configuration settings to revert to
factory defaults upon the next system reboot.
Proceed with 'snmp interfaces rfc1213'? [confirm]
Use the no version to return to the default method of interface numbering.
See snmp-server interfaces rfc1213.

Monitoring Interface Tables

Use the following command to view the configuration of your interface tables.
Use to display a list of interface types that are compressed in the interface tables and
the interface numbering method configured on the router.
Field descriptions
Compressed(Removed) Interface Types—List of interface types that are removed
from the ifTable and ifStackTable
Armed Interface Numbering Mode—Interface numbering method configured on the
router: RFC1213, RFC2863
maxIfIndex—Maximum value that the system will allocate to the ifIndex field
maxIfNumber—Maximum number of interfaces allowed in the ifTable
Interface Description Setting—Method used to encode the ifDescr and ifName objects:
common, legacy, proprietary
Example
host1#show snmp interfaces
Compressed(Removed) Interface Types:
HDLC, FT1, ATM, ATM1483
Armed Interface Numbering Mode:
RFC1213, maxIfIndex=65535, maxIfNumber=65535
Interface Description Setting: proprietary
See show snmp interfaces.
This section provides information for:
IP Hosts on page 157
Trap Categories on page 157
Copyright © 2010, Juniper Networks, Inc.