Assign An Ip Address To The Default Group; Log Out - Alcatel OmniAccess 512 Getting Started Manual

o Important Notes o
Do not use commas when specifying a
aging timer value. For example,
MAC
the entry
If you want to use the Group aging
timer, enter as the value for the
aging timer.
If you entered a new
value, you must reboot the switch
before the changes will take effect.
No confirmation message will appear onscreen. To
verify that the switch's
MAC
type
.

7. Assign an IP Address to the Default Group

Your switch is configured with a default Group and
. You can add Groups and
VLAN
the switch software. To get started, you can use the
default group and default
address for this switch. (The default
.) To modify Group
complete the following steps:
a. To assign or modify the default Group and
Address, type the following at the
and press
->
where is the default group and VLAN, and
is the
ip-address
router port (for example,
will result in an error.
MAC
aging timer has been set,
at the prompt and press
CLI
s later through
VLAN
to configure the
VLAN
address is
IP
routing parameters,
IP
prompt
CLI
:
Address for a specific virtual
IP
).
b. No confirmation message will appear onscreen.
Only the system prompt (
See your switch manual to set other parameters.
You have now set up all of the basic software parame-
ters you need to begin managing your switch. Once
your switch is connected to the network, you can use
Telnet or
FTP
your network.
More Information on Switch Commands?
At this point, you can begin configur-
ing other switch parameters. See your
OmniAccess 512 User Manual and any
supplements for information on all
switch commands.

8. Log Out

You have now completed the initial software set-up.
You can exit the switch by typing
IP
pressing
VLAN
) will appear.
->
to access the switch software through
.
or and
Setting Up Software 11