Table of Contents
Advertisement
Overview
Chapter 1
System Indicator LEDs
1
The system LEDs, located on the front of the switch, display the status of system
power and operation.
T
1-1
System LEDs
ABLE
LED
Power
Status
Fast Ethernet WAN Port
2
The Alcatel OmniAccess 4302 WLAN Switch provides one 10/100 Mbps Fast
Ethernet (FE) port to connect to a WAN link. The FE port automatically senses and
negotiates speed, duplex, and MDI/MDX settings.
From the WebUI and the CLI, this port address is interface fastethernet 1/0.
The port has two LEDs above the port: a LNK/ACT LED on the left and a 100 LED
on the right. During operation, these LEDs provide the following information:
Status
LNK/ACT LED
Off
Green
Flashing
Green
100 LED
Off
Green
Use a Category 5 (or better) UTP cable with RJ-45 connectors to connect to
devices up to 100m (325 feet) away.
4
OmniAccess 4302 WLAN Switch
Installation Guide
State
Description
Green
WLAN Switch is powered on.
Off
WLAN Switch is powered off.
Green
WLAN Switch has booted and is functioning
properly.
Off
WLAN Switch is booting, loading software, or has
failed.
N
:
OTE
Description
No Ethernet link on the port.
An Ethernet link has been established on the port, but no data is
currently being transmitted or received.
The port is transmitting or receiving data. The flashing rate is
fixed and is not proportional to your network activity.
The Ethernet link speed is 10 Mbps.
The Ethernet link speed is 100 Mbps.
This LED remains off until you perform the
initial setup described in the Alcatel Quick
Start Guide (included in the Accessory Kit).
031986-00
February 2006
Advertisement
Table of Contents
