Configuring Dynamic Link Aggregate Groups
Configuring Ports to Join and Removing Ports in a Dynamic
Aggregate Group
The following subsections describe how to configure ports with the same administrative key (which allows
them to be aggregated) or to remove them from a dynamic aggregate group with the
key
command.
Configuring Ports To Join a Dynamic Aggregate Group
To configure ports with the same administrative key (which allows them to be aggregated) enter lacp agg
followed by the slot number, a slash (/), the port number, actor admin key, and the user-specified actor
administrative key (which can range from 0 to 65535).
In addition, ports must be configured sequentially and the first port configured must begin with port
number 1, 9, 17, or 25 on an OmniSwitch 6624 and 6600-U24 or 1, 9, 17, 25, 33, 41, 49, or 51 on an
OmniSwitch 6648. (In a stack, ports on different switches can be assigned to the same dynamic aggregate
group.) Ports also must be the same speed (i.e., all 10 Mbps, all 100 Mbps, or all 1 Gbps). See the tables
and figures on the next page for more information.
Note. You can configure up to 16 ports to join a single aggregate group in a stack as long as no more than
8 ports are configured on a single switch.
page 11-12
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Dynamic Link Aggregation
lacp agg actor admin
April 2004