Setting Ethernet Port Parameters
Note. Since the interfaces ifg command is only supported on Gigabit interfaces only the gigaethernet
keyword should be used.
Resetting Statistics Counters
The
interfaces no l2 statistics
range of ports, or all ports on a switch (slot).
To reset Layer 2 statistics on an entire slot enter interfaces followed by the slot number and no l2
statistics. For example, to reset all Layer 2 statistics counters on slot 2 enter:
-> interfaces 2 no l2 statistics
To reset Layer 2 statistics on a single port enter interfaces followed by the slot number, a slash (/), the
port number, and no l2 statistics. For example, to reset all Layer 2 statistics counters on port 3 on slot 2
enter:
-> interfaces 2/3 no l2 statistics
To reset Layer 2 statistics on a range of ports enter interfaces followed by the slot number, a slash (/), the
first port number, a hyphen (-), the last port number, and no l2 statistics. For example, to reset all Layer 2
statistics counters on ports 1 through 3 on slot 2 enter:
-> interfaces 2/1-3 no l2 statistics
As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet
before the slot number. For example, to reset all Layer 2 statistics counters on port 3 on slot 2 and docu-
ment the port as Fast Ethernet:
-> interfaces fastethernet 2/3 no l2 statistics
Note. The
show
interfaces,
be used to display Layer 2 statistics (e.g., input and output errors, deferred frames received, unicast pack-
ets transmitted). For information on using these commands, see the OmniSwitch CLI Reference Guide.
Configuring Flood Rates
The following subsections describe how to enable the maximum flood rate (see
Flood Rate" on page
Flood Rate for Multicast Traffic" on page
(slot), a specific port, or a range of ports (see
Enabling the Maximum Flood Rate
The
interfaces flood
only one slot can be configured at a time. You cannot configure specific ports or ranges of ports.
Note. To enable flood multicasting on an interface, see
Traffic" on page
1-15.
page 1-14
command is used to reset all Layer 2 statistics counters on a specific port, a
show interfaces
accounting, and
1-14), enable the maximum flood rate for multicast traffic (see
1-15), and how to configure the flood rate on an entire switch
"Configuring Flood Rate Values" on page
command can be used to enable the maximum flood rate for a switch (slot). Note that
OmniSwitch 6624/6648 Network Configuration Guide
show interfaces counters
"Enabling the Maximum
"Enabling Maximum Flood Rate for Multicast
Configuring Ethernet Ports
commands can
"Enabling Maximum
1-15).
April 2004