Table of Contents
Advertisement
P6_PIN, 7-3
P6_REG, 7-3
considerations, 6-15
PPW, 16-8, 16-9, 16-35
PSW, 5-4, 5-15
PTSCON, 5-21
PTSCOUNT, 5-19
PTSSEL, 5-4
PTSSRV, 5-4
Px_DIR, 6-5, 6-9, 6-10, 6-11
Px_MODE, 6-5, 6-9, 6-10, 6-11
Px_PIN, 6-5, 6-7, 6-9, 6-16, 6-18
Px_REG, 6-5, 6-9, 6-10, 6-11, 6-16, 6-17,
6-18
RALU, 2-4, 2-5, 4-12
SBUF_RX, 7-3
SBUF_TX, 7-3
SLP_CMD, 9-2, 9-5
SLP_CON, 9-5, 9-14, 9-15
SLP_STAT, 9-2, 9-5, 9-14, 9-15, 9-16
SP_BAUD, 7-4, 7-10, 16-35
SP_CON, 7-4, 7-9, 16-35
SP_PPW, 16-8, 16-9
SP_STATUS, 7-4, 7-13
SSIO0_BUF, 8-3, 8-5
SSIO0_CON, 8-3
configuring for handshaking, 8-6
SSIO1_BUF, 8-3
SSIO1_CON, 8-3
configuring for handshaking, 8-6
SSIO_BAUD, 8-3, 8-9
SSIOx_BUF, 8-8
SSIOx_CON, 8-10
using, 3-9
WSR, 4-14, 5-15
Reserved bits, defined, 1-4
Reset, 13-9, 15-4
and bus-hold protocol, 15-20
and CCB fetches, 4-4
circuit diagram, 13-11
status
CLKOUT/P2.7, 6-7, 6-13
I/O and control pins, B-20, B-21, B-22
with illegal IDLPD operand, 13-12
with RESET# pin, 13-10
with RST instruction, 13-9, 13-12
with watchdog timer, 13-12
RESET#, 13-1, 14-2, B-16
and CCB fetch, 13-8
and CLKOUT, 13-9
and device reset, 13-8, 13-9, 13-10, 15-20
and ONCE mode, 14-9
and powerdown mode, 14-6
and programming modes, 16-14
idle, powerdown, reset status, B-20, B-22,
B-23
Resonator, ceramic, 13-7
RET instruction, A-2, A-30, A-46, A-51
RISM, 16-34, 16-35
defaults, 16-34, 16-35
examples
beginning execution, 16-42
loading program into RAM, 16-40
programming the PPW, 16-39
reading the OTPROM, 16-40
setting the PC, 16-42
writing to OTPROM, 16-43
ROM-dump mode, 16-31
security key verification, 16-31
RS-232C interface, 16-32
RST instruction, 3-11, 13-9, 13-12, A-3, A-31,
A-47, A-53, A-59
Run-time programming, 16-44–16-45
code example, 16-45
RXCAN, B-16
RXD, 7-2, 16-12, B-16
and SIO port mode 0, 7-4
and SIO port modes 1, 2, and 3, 7-6
S
Sampled input, 15-9, B-8
SBUF_RX, C-89
SBUF_TX, C-89
SC0, 8-5, B-16
configuring for handshaking, 8-6
SC1, 8-5, B-16
configuring for handshaking, 8-6
SCALL instruction, A-3, A-31, A-42, A-48, A-51
SD0, 8-5, B-16
SD1, 8-5, B-16
Security key
and serial port programming mode, 16-32
verification, 16-31
Selecting up or down counting, 10-18, 10-19,
C-75, C-76
Index-11
Advertisement
Table of Contents
