8XC196K x, J x , CA USER'S MANUAL
SLP_CMD
SLP_CMD
(8XC196K x )
The slave port comand (SLP_CMD) register accepts commands from the master to the slave. The
commands are defined by the device software. The slave can read from and write to this register. The
master can only write to it. To write to SLP_CMD (rather than P3_PIN) the master must first write "1" to
the pin selected by SLP_CON.2.
7
8XC196K x
Bit Number
7:0
Command Value
This register is used to hold commands from the master to the slave.
C-64
Reset State:
Command Value
Function
Address:
1FFAH
00H
0