Intel 8XC196K Series User Manual page 518

Name Type
†
SLP7:0 I/O
†
SLPALE I
†
SLPCS# I
†
SLPINT O
†
SLPRD# I
†
SLPWR# I
†
T1CLK I
T2CLK I
†
This signal is not implemented on the 8XC196J x or 87C196CA (see "Design Considerations for
8XC196JQ, JR, JT, and JV Devices" on page 2-14 or "Design Considerations for 87C196CA Devices" on
page 2-13).
††
This signal is not implemented on the 8XC196J x (see "Design Considerations for 8XC196JQ, JR, JT, and
JV Devices" on page 2-14).
Table B-6. Signal Descriptions (Continued)
Slave Port Address/Data bus
Slave port address/data bus in multiplexed mode and slave port data bus in
demultiplexed mode. In multiplexed mode, SLP1 is the source of the internal
control signal, SLP_ADDR.
SLP7:0 are multiplexed with AD7:0, P3.7:0, and PBUS.7:0.
Slave Port Address Latch Enable
Functions as either a latch enable input to latch the value on SLP1 (with a
multiplexed address/data bus) or as the source of the internal control signal,
SLP_ADDR (with a demultiplexed address/data bus).
SLPALE is multiplexed with P5.0, ADV#, and ALE.
Slave Port Chip Select
SLPCS# must be held low to enable slave port operation.
SLPCS# is multiplexed with P5.1 and INST.
Slave Port Interrupt
This active-high slave port output signal can be used to interrupt the master
processor.
SLPINT is multiplexed with P5.4 and the ONCE# function (KR, KQ) or a special
test-mode-entry pin (KS, KT). See P5.7:0 for special considerations.
Slave Port Read Control Input
This active-low signal is an input to the slave. Data from the P3_REG or
SLP_STAT register is valid after the falling edge of SLPRD#.
SLPRD# is multiplexed with P5.3 and RD#.
Slave Port Write Control Input
This active-low signal is an input to the slave. The rising edge of SLPWR#
latches data on port 3 into the P3_PIN or SLP_CMD register.
SLPWR# is multiplexed with P5.2, WR#, and WRL#.
Timer 1 External Clock
External clock for timer 1. Timer 1 increments (or decrements) on both rising
and falling edges of T1CLK. Also used in conjunction with T1DIR for quadrature
counting mode.
and
External clock for the serial I/O baud-rate generator input (program selectable).
T1CLK is multiplexed with P6.2.
Timer 2 External Clock
External clock for timer 2. Timer 2 increments (or decrements) on both rising
and falling edges of T2CLK. Also used in conjunction with T2DIR for quadrature
counting mode.
T2CLK is multiplexed with P1.0 and EPA0.
SIGNAL DESCRIPTIONS
Description
B-17