Drive Shaft Boot And Protector; Wheel Bearing - BRP can-am RENEGADE 500 2015 Operator's Manual

vmo2012-012-062_a
ROTATE BULB COUNTERCLOCKWISE
Remove bulb socket from taillight.
Installation is the reverse of the re-
moval procedure.
Drive Shaft Boot and
Protector

Drive Shaft Boot and Protector

Inspection
Visually inspect drive shaft protectors
and boots conditions.
Check protectors for damage or rub-
bing against shafts.
Check boots for cracks, tears, leaking
grease etc.
Repair or replace damaged parts as
necessary.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
vmo2012-015-003_a
TYPICAL — FRONT OF VEHICLE
1. Drive shaft boots
2. Drive shaft protector
vmo2012-015-002_a
TYPICAL — REAR OF VEHICLE
1. Drive shaft boots
2. Drive shaft protector

Wheel Bearing

Wheel Bearing Inspection
Place vehicle on a level surface.
Apply parking brake.
Lift and support vehicle.
Secure vehicle on jack stands.
Push and pull the wheels from the up-
per edge to feel the play.
WARNING
______________
MAINTENANCE PROCEDURES
113