Drive Belt - BRP SKI-DOO MX Z X 600RS 2016 Manual

mbl2009-008-008_a
A. View from front
B. View from right side
1. Pop rivets
2. Exhaust deflector
3. From inside engine compartment, place 3
washers (predelivery kit) on rivets.
mbl2009-008-009_a
1. Washers on rivets
4. Pop the rivets.
5. Reinstall muffler.

Drive Belt

1. Remove drive belt guard.
2. Loosen the lock nut on the set screw.
3. Completely open the driven by turning the set
screw clockwise.
4. Clean drive and driven pulleys using
FLANGE CLEANER (P/N 413 711 809)
5. Install drive belt is with arrows in the direction
of rotation.
PREDELIVERY
mmo2011-002-006_a
TYPICAL
1. To be pointed in the direction of rotation
6. To adjust drive belt, turn the set screw 1/4 turn
at a time, then rotate the driven pulley to prop-
erly set the belt between the pulley sheaves.
7. Measure belt deflection using a straight edge
and the
414348200
8. Adjust drive belt deflection as per specification.
NOTE:
crease the distance between the sheaves and
out (counter-clockwise) to decrease the distance.
Tighten the lock nut after the belt adjustment has
been made.
PULLEY
A32D34A
.
JAM NUT
2016-5
PARTS TO BE INSTALLED
TENSIOMETER (P/N 414 348 200)
DRIVE BELT DEFLECTION
Deflection
Force applied
Turn the set screw in (clockwise) to in-
.
27 mm to 37 mm
(1.06 in to 1.46 in)
11.3 kg (25 lb)
9 / 13