Removing And Installing Sealing Flange On Gearbox Side - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Installing intermediate plate
– Insert intermediate plate on sealing flange -top arrow- and
push onto the dowel sleeves -bottom arrows-.
Sealing flange on the gearbox side - tightening torque and tight‐
ening order
– Tighten screws in steps in the given sequence:
Stage Screws
1. -1 ... 6-
2. -1 ... 6-
2.4 Removing and installing sealing flange
on gearbox side
Special tools and workshop equipment required
♦ Assembly tool - T10134-
♦ Depth gauges , e.g. -VAS 6082-
♦ 3x screw M6x35
♦ 2x screw M7x35
Press out sealing flange with rotor
• Gearbox removed.
– Remove the flywheel
⇒ "2.5 Removing and installing flywheel", page 73
Note
For a clearer illustration, see the following work sequences while
the engine is removed.
– Unhook intermediate plate at the sealing flange and dowel
sleeves -arrows-.
66
Rep. gr.13 - Crankshaft group
Tightening torque
by hand as far as the stop
crosswise in steps up to 13 Nm
.