Removing And Installing Fuel Pressure Sender G247 - Skoda Octavia III 2013 Workshop Manual

– Separate electrical plug connection -2-.
– Loosen union nuts -1- - to do so, hold on hexagon against the
fuel distributor. Afterwards release by hand.
– Suction the dirt out of the fuel distributor hole (thread and con‐
tact surface). To do so do not use any mechanical tools.
– Close the open port on the fuel rail with a clean plugs.
Install
• Tightening torque
⇒ "2.2 Fuel distributor - summary of components", page 325
Note
Replace the fuel pressure regulating valve - N276- each time
♦
it is removed.
Moisten the threaded insert and the biting edge of the fuel
♦
pressure regulating valve - N276- with diesel fuel.
– Tighten the union nut by hand.
– Align the new control valve so that the connecting cable is re-
installed free of tension after the plug has been repositioned.
– Counterhold housing hexagon of the regulating valve in this
position using a wrench or pliers (such as water pump pliers).
– To tighten the union nuts use a suitable torque wrench with an
open-end wrench (size 30).
– Filling and bleeding the fuel system
⇒ "1.3 Filling/bleeding the fuel system", page 321
4.6 Removing and installing fuel pressure
sender - G247-
Special tools and workshop equipment required
♦ Socket insert size 27 - T40218-
♦ Cleaning and degreasing agent , e.g. -D 009 401 04-
♦ Protective goggles and gloves
Removing
Note
Safety precautions when working on the fuel supply system
♦
⇒ "2 Safety instructions", page 3
Observe rules for cleanliness
♦
⇒ "3.1 Rules of cleanliness", page 6
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
WARNING
Wear protective gloves and protective googles when working
with grease remover!
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
.
.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
4. Senders and sensors
347