Skoda Octavia III 2013 Workshop Manual page 290

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Set primary pressure at setting wheel -arrow- by turning pres‐
sure control valve - VAS 6551/6- .
• Specified value: Pressure 0.45 MPa (4.5 bar)
– From this point no longer move position of the setting wheel
-arrow-.
– Drain measuring container.
– Repeat function
check fuel pump conveying pressure/
.
quantity
Note
The Die fuel system pressurisation pump - G6- is now activated
for 30 seconds.
– Check fuel delivery quantity in the measuring vessel.
•
Specified value: Minimum fuel flow rate 1100 cm
If the minimum fuel delivery volume is not reached
– Check fuel lines in the engine compartment for possible re‐
strictions (kinks) or blockages and damage.
– Check the fuel lines in the engine compartment for tightness.
If no fault is found:
Check the fuel delivery quantity before the fuel filter, to do so pro‐
ceed as follows:
Check the fuel flow rate before the fuel filter
– Remove fuel feed line -1-
⇒ "2.12 Separating push-on couplings", page 249
282
Rep. gr.20 - Fuel supply system
3
/30 s.
.