Skoda Octavia III 2013 Workshop Manual page 189

Removing
Note
Fit all heat protection sleeves on again in the same place when
installing.
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Drain coolant ⇒ "1.2 Draining and filling coolant", page 151
– Remove rear coolant pipe
⇒ "3.7 Removing and installing the rear coolant pipe",
page 179 .
– Remove left coolant pipe
⇒ "3.6 Remove and install the left coolant pipes", page 178
– Remove the front silencer
⇒ "1.2 Removing and installing exhaust pipe", page 380
For vehicles with engine identification characters CLHA, CLHB,
CKFB, CKFC, CUPA, CRVC
– Open heat protection sleeve -1-.
– Take electrical plug connection-4 - out of the holder, discon‐
nect and expose electric cable.
– Disconnect electrical plug connections -3-, -5-, expose electric
wiring loom.
– Unscrew screw -2-, lay bracket with differential pressure trans‐
mitter - G505- to the rear.
For vehicles with engine identification characters CRKB, CRMB,
CUNA
– Open heat protection sleeve -1-.
– Disconnect electrical plug connections -3-, -4-, -5-, -6- expose
electric wire harness.
– Release screw -2-.
– Detach vacuum hose -arrow- and put to one side.
– Place the bracket with the differential pressure transmitter to
the rear.
Continued for all vehicles
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
.
.
181
3. Coolant pipes