Skoda Octavia III 2013 Workshop Manual page 266

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Ensure the plug connection fits tightly:
• The plug -2- on the metal plate ring -3- must be pushed on
firmly.
• The contact peg -1- must be hung on the fuel tank -4- and
secured with the spacer bush -5-.
WARNING
Risk from electrostatic charge.
♦ After installing, use an ohmmeter to test the electrical con‐
nection of the threaded ring on the fuel filler neck at a bare
point on the body.
• Specified value approximately 0 Ω.
– Check that the fuel lines are clipped to the fuel tank.
– Position fuel tank with tensioning straps with the engine and
gearbox jack - V.A.G 1383 A- at the vehicle underside.
– When positioning the fuel tank, ensure that the fuel filler neck
is inserted correctly into the opening on the body.
Note
New screws for tensioning strap are longer than series screws,
note the part number⇒ ETKA - Electronic Catalogue of Original
Parts
Further installation occurs in reverse order.
2.13.2 Removing and installing the fuel delivery
unit, vehicles with four-wheel drive
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
♦ Engine and gearbox jack , e.g. -V.A.G 1383 A-
Removing
Note
Drain the fuel tank
♦
⇒ "2.7 Extract fuel from the fuel tank", page 223
Safety precautions when working on the fuel supply system
♦
⇒ "2 Safety instructions", page 3
Observe rules for cleanliness
♦
⇒ "3.1 Rules of cleanliness", page 6
– Switch off ignition and pull out ignition key.
– Removing rear seat bench ⇒ Body Work; Rep. gr. 72 .
258
Rep. gr.20 - Fuel supply system
.
.
.