Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Unscrew the lambda probe after catalytic converter - G130-
-arrow- with a socket wrench from the socket insert for lambda
probe - 3337- .
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
New lambda probes are coated with an assembly paste; the
♦
paste is not allowed to reach to slots on the body of the probe.
For a re-used lambda probe, only coat the thread with hot bolt
♦
paste . This paste must not come into contact with the slots of
the lambda probe body.
The electrical wiring of the lambda probe must be attached to
♦
the same position when installing. This prevents the lambda
probe cable from coming into contact with the exhaust pipe.
Tightening torques
♦
⇒ "5.1 Lambda probe - Summary of components", page 351
♦ Sound dampening system - Summary of components ⇒ Body
Work; Rep. gr. 50 .
♦ Underfloor trim panel - Summary of components ⇒ Body
Work; Rep. gr. 50 .
354
Rep. gr.23 - Mixture preparation - injection
.