Skoda Octavia III 2013 Workshop Manual page 380

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
❑ removing and installing
14 - Separation point
❑ for repairs
❑ marked with recesses around the circumference
❑ Separation point
Installation position of gasket between exhaust gas cleaning mod‐
ule and pre-exhaust pipe
• The square catch of the gasket -arrow- must be in the groove
of the exhaust gas cleaning module.
Installation position of clamping sleeve for pre-exhaust pipe
• Angle -α- = 0 ± 30°.
Installation position of front clamp
– Install clamping sleeve in the angle position shown.
• Angle -α- = approximately 20°.
• Bolted connection to the right.
• Nuts upwards.
Installation position of rear clamp
– Install clamping sleeve in the angle position shown.
• Angle -α- = approximately 30°.
• Bolted connection to the left.
• Nut downwards
372
Rep. gr.26 - Exhaust system
⇒ "1.4 Removing and installing rear silencer", page 381
⇒ "1.5 Replacing middle or rear silencer", page 385