Removing And Installing Top Toothed Belt Guard - Skoda Octavia III 2013 Workshop Manual

13 - Guide pulley
14 - High pressure pump
❑ Summary of components
15 - Hub
❑ for high pressure pump
❑ Summary of components
❑ There must not be any oil present between the lock hub and the toothed belt pulley
16 - Toothed belt pulley high pressure pump
❑ Summary of components
❑ There must not be any oil present between the lock hub and the toothed belt pulley
17 - Nut
❑ Do not additionally oil threads and collar
❑ Tightening torque Pos. -4-
18 - O-ring
❑ replace after removal
❑ Moisten with coolant
19 - Coolant pump
❑ removing and installing
20 - Screw
❑ Tightening torque Pos. -11-
⇒ "2.1 Summary of components - coolant pump and coolant thermostat", page 159
1.8 Removing and installing top toothed belt
guard
Special tools and workshop equipment required
♦ Extension SW 17 from the set of tools - T10395-
Note
Observe rules for cleanliness
⇒ "3.1 Rules of cleanliness", page 6
Removing
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Disconnect fuel lines -1-, -2-, to do so, first press hose coupling
downwards arrow -A-, then press release buttons down arrow
-B- ⇒ "2.12 Separating push-on couplings", page 249
– Remove hose coupling with pressed release buttons.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ "3.1 Summary of components - high pressure pump", page 338
⇒ "3.1 Summary of components - high pressure pump", page 338
⇒ "3.1 Summary of components - high pressure pump", page 338
⇒ "3.1 Summary of components - high pressure pump", page 338
⇒ "2.4 Removing and installing coolant pump", page 163
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
1. Removing and installing a V-ribbed belt and a toothed belt
45