Summary Of Components - Front, Middle And Rear Silencer, Vehicles With Four-Wheel Drive (Engine Identification Characters Clha, Ckfc, Crmb, Cuna) - Skoda Octavia III 2013 Workshop Manual

1.1.5 Summary of components - front, middle and rear silencer, vehicles with four-
wheel drive (engine identification characters CLHA, CKFC, CRMB, CUNA)
1 - Gasket
❑ replace after removal
❑ Check fitting position
⇒ page 380
2 - Clamping sleeve
❑ replace
❑ Fitting position
⇒ page 380
❑ 7 Nm
3 - Support
❑ replace if damaged
4 - Exhaust flap control unit -
J883-
❑ removing and installing
⇒ "1.3 Removing and in‐
stalling the exhaust flap
control unit J883 ", page
381
5 - Screw
❑ 23 Nm
6 - Pre-exhaust pipe
❑ removing and installing
⇒ "1.2 Removing and in‐
stalling exhaust pipe",
page 380
❑ ustawienie układu wy‐
dechowego bez naprę‐
żeń
⇒ "1.6 Aligning exhaust
system free of stress",
page 386
7 - Front clamping sleeve
❑ before tightening, align
exhaust system free of stress
❑ Fitting position ⇒ page 380
❑ Tighten bolted connections evenly
❑ 30 Nm
8 - Middle and rear silencer
❑ ustawienie układu wydechowego bez naprężeń
⇒ "1.6 Aligning exhaust system free of stress", page 386
❑ removing and installing
9 - Retaining strap
❑ replace if damaged
10 - Hanger
❑ replace if damaged
11 - Nut
❑ 20 Nm
12 - Rear tunnel bridge
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ "1.6 Aligning exhaust system free of stress", page 386
⇒ "1.4 Removing and installing rear silencer", page 381
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Removing and installing exhaust pipes/silencers
379