Removing And Installing Glow Plugs - Skoda Octavia III 2013 Workshop Manual

6 - Sealing flange on the gearbox side
❑ removing and installing
7 - Rotor
❑ for engine speed transmitter - G28-
❑ removing and installing
8 - Engine speed transmitter - G28-
❑ removing and installing
9 - Screw
❑ 4.5 Nm
1.2

Removing and installing glow plugs

Note
Metal glow plugs are installed in this engine.
Special tools and workshop equipment required
♦ Flexible-head wrench SW 10 -3220-
♦ Pliers - 3314-
♦ Cleaning and degreasing agent , e.g. -D 009 401 04-
♦ Protective goggles and gloves
♦ Socket insert 12 mm - VAS 6454- , only for engine identifica‐
tion characters CRKB, CRMB, CUNA
Removing
Glow plug variants
1 - Glow plugs with combustion chamber pressure sender - on‐
ly for cylinder 3 with engine identification characters CRKB,
CRMB, CUNA
2 - Glow plugs without combustion chamber pressure sender
Observe all safety measures and notes for assembly work on the
fuel system and on the injection system as well as the rules for
cleanliness ⇒ "3 Repair instructions", page 6
– Switch off ignition and pull out ignition key.
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
Caution
Risk of damaging support sleeves.
♦ Only press pliers - 3314- for disconnecting glow plug con‐
nectors so far together that they grip the support sleeve
collar securely without damaging it.
– Open holding clamps of the electrical wiring loom and discon‐
nect the electrical plug connections from the glow plugs as
follows.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ "2.4 Removing and installing sealing flange on gearbox side", page 66
⇒ "2.4 Removing and installing sealing flange on gearbox side", page 66
⇒ "1.5 Removing and installing engine speed transmitter G28 ", page 424
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
421
1. Glow Plug System