Skoda Octavia III 2013 Workshop Manual page 254

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
2.11.2 Removing and installing fuel gauge
sender 2 - G169-
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
♦ Wrench for union nut - T30101 (3087)-
•
The fuel tank must not be more than
Note
♦ If necessary drain the fuel tank
⇒ "2.7 Extract fuel from the fuel tank", page 223
Safety precautions when working on the fuel supply system
♦
⇒ "2 Safety instructions", page 3
Observe the regulations concerning cleanliness when working
♦
on the fuel supply/injection system
⇒ "3.1 Rules of cleanliness", page 6
Make sure that the sender for fuel gauge display is not bent.
♦
Removing
– Move front seats all the way forward.
– Switch off ignition.
– Removing rear seat bench ⇒ Body Work; Rep. gr. 72 .
– Unclip cover -1- at retaining tabs -arrows-, using removal
wedge - 3409- .
– Unclip sealing grommet -1- downwards from the cover -2-.
– Guide the cover -2- backward at the electric wiring loom -3-.
246
Rep. gr.20 - Fuel supply system
1
/ 3 full.
.
.
.