Skoda Octavia III 2013 Workshop Manual page 405

– Open clamp -1- and position it on the flared opening of the
exhaust gas cleaning module.
– Unscrew the remaining screws in the order -4 ... 2-.
Right-hand drive
– Push engine forwards with the assistance of a second me‐
chanic.
Continued for all vehicles
– Swivel the exhaust gas cleaning module downwards away
from the engine and push it upwards.
– Pull retaining bracket out of the suspension catch of the ex‐
haust gas cleaning module and remove the exhaust gas clean‐
ing module downwards.
Install
• Assembly aid - T10511- positioned on engine
Note
Ensure that the retaining bracket of the assembly aid -
♦
T10511- pivoted in the front wall direction is - »open«-.
Replace seals, self-locking nuts and gripper clamp for exhaust
♦
gas cleaning module.
Fit all cable straps back at the same points when re-installing.
♦
Caution
Risk of stress fractures and engine damage caused by the
built-in exhaust gas cleaning module being under tension.
♦ Before installation, ensure that these balancing elements
are not stiff or tight.
♦ The balancing element must turn freely in the thread.
♦ Lubricant must only be applied to the thread, the retaining
lugs must remain »clean«.
♦ The screw retaining lugs must be bent far enough for the
balancing element to be moved when the screw is
screwed in.
– Check for and ensure ease of movement of the balancing el‐
ements -arrow-.
– Fully unscrew balancing elements in the clockwise direction
(left-hand thread).
– Clean stiff threads and moisten them with lubricant if neces‐
sary.
Caution
Retaining lugs of the balancing elements must not be mois‐
tened with lubricants of any kind. Reducing the friction would
impair the function of the balancing element.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Cleansing exhaust emissions
397