Injection Units/Fuel Distributor; Summary Of Components - Injection Units (Injectors) - Skoda Octavia III 2013 Workshop Manual

2

Injection units/fuel distributor

⇒ "2.1 Summary of components - injection units (injectors)", page
323
⇒ "2.2 Fuel distributor - summary of components", page 325
⇒ "2.3 Check injection units", page 326
⇒ "2.4 Adjust the correction values for injection units",
page 326
⇒ "2.5 Check injection unit return quantity with engine running",
page 326
⇒ "2.6 Check injection unit return flow quantity at starter speed",
page 329
⇒ "2.7 Carry out the vacuum test of the injection units",
page 330
⇒ "2.8 Removing and installing the injection units", page 331
⇒ "2.9 Removing and installing high pressure lines", page 334
⇒ "2.10 Removing and installing the fuel distributor", page 336
2.1

Summary of components - injection units (injectors)

1 - Gasket ring
❑ in the cylinder head cov‐
er
❑ replace after removal
⇒ "1.1 Assembly over‐
view - cylinder head
cover", page 85
2 - Copper disc
❑ replace after removal
3 - O-ring
❑ replace after removal
4 - Injection unit
❑ removed injection units,
high pressure lines and
clamping claws to be re-
installed must only be
mounted again at the
same cylinder.
❑ removing and installing
⇒ "2.8 Removing and in‐
stalling the injection
units", page 331
❑ Observe part number ⇒
ETKA - Electronic Cata‐
logue of Original Parts
5 - O-ring
❑ replace after removal
6 - Fuel return-flow line
❑ to fuel tank
❑ must not be kinked,
damaged or blocked
❑ do not disassemble
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Injection units/fuel distributor
323