Skoda Octavia III 2013 Workshop Manual page 62

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Loosen nut -arrow- for high pressure pump toothed belt pulley
by approximately 90°, use counterholder - T10051- to do so.
– Loosen nut -1- for tensioning pulley.
– Carefully turn eccentric of the tensioning pulley with offset
screwdriver - T10264- clockwise -arrow- until the tensioning
pulley can be interlocked with the rig tool - T10265- .
– Then turn the eccentric of the tensioning pulley with the offset
screwdriver - T10264- clockwise -arrow- up to the stop and
tighten nut -1- by hand.
Caution
Risk of damage through reversing the rotation direction of an
already used toothed belt.
♦ Mark the direction of rotation with chalk or a felt-tip pen for
the re-installation before removing the toothed belt pulley.
– First remove the toothed belt from the coolant pump and then
from the remaining toothed belt gears.
Installing (set the timing)
Note
The engine must be cold for performing installation work on the
toothed belt.
Caution
Risk of damage to valves and piston crowns.
♦ When rotating the camshaft, the crankshaft must not be
positioned at "TDC" with any one piston.
Requirements:
54
Rep. gr.13 - Crankshaft group