Replace The Needle Bearing In The Crankshaft - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
8 - Crankshaft
❑ for vehicles with manual gearbox, no needle bearing must be installed; remove needle bearing if nec‐
essary ⇒ "3.2 Replace the needle bearing in the crankshaft", page 76
❑ for vehicles with dual clutch gearbox, needle bearing must be installed in the crankshaft; install needle
bearing if necessary
❑ New axial clearance: 0.07...0.17 mm
Wear limit: 0.37 mm
❑ Crankshaft bearing journals ∅ 54.00 mm
❑ Rod bearing journals (1.6 l engine): ∅ 47.80 mm
❑ Rod bearing journals (2.0 l engine): ∅ 50.90 mm
3.2 Replace the needle bearing in the crank‐
shaft
Special tools and workshop equipment required
♦ Interior extractor - Kukko 21/2-
♦ Countersupport - Kukko 22/1-
♦ Centering mandrel - T30029 (3176)-
Note
For vehicles with manual gearbox, no needle bearing must be
♦
installed.
For vehicles with dual clutch gearbox, needle bearing must be
♦
installed in the crankshaft; ⇒ ETKA - Electronic Catalogue of
Original Parts .
Precondition
• If the engine and transmission were separated, always replace
the needle bearing -arrow-.
• The leading edges of the internal extractor must not have bro‐
ken out.
Removing
• Gearbox removed.
76
Rep. gr.13 - Crankshaft group
⇒ "3.2 Replace the needle bearing in the crankshaft", page 76