Skoda Octavia III 2013 Workshop Manual page 86

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
1 - Screw
❑ replace after removal
❑ Oil threads and contact
surface.
❑ 30 Nm + torque a further
1
90° ( / 4 turn)
2 - Conrod bearing cap
❑ Check fitting position
❑ as a result of the con‐
rods separated in the
cracking process, the
conrod bearing cap fits
only in one position and
only to the relevant con‐
rod
❑ Mark assignment to the
cylinder in colour -B-
❑ Fitting position: mark‐
ings -A- point toward
belt pulley side
3 - Bearing shells
❑ Fitting position
⇒ page 81
❑ replace used bearing
shells
❑ Pay attention to version:
top bearing shell (to‐
wards the piston) must
be in long wearing ma‐
terial. Distinguishing
feature of new bearing
shells: black marking on
contact surface near the
separation point
❑ pay attention to correct
position
4 - Conrod
❑ Renew as set only.
❑ Mark assignment to the conrod bearing cap and to the cylinder in colour -B-
❑ Fitting position: markings -A- towards belt pulley side
❑ with cracked conrod bearing cap
❑ separate new conrod
❑ Axial play wear limit: 0.37 mm
5 - Pressure relief valve
❑ replace without sealant
❑ removing and installing
❑ 27 Nm
6 - Oil injection nozzle
❑ for piston cooling
❑ removing and installing
7 - Circlip
❑ Qty. 2
❑ replace after removal
78
Rep. gr.13 - Crankshaft group
⇒ "3.6 Separating new conrod", page 84
⇒ page 82
⇒ page 82