Skoda Octavia III 2013 Workshop Manual page 45

1 - Poly V-belt
❑ check for wear
❑ mark the direction of ro‐
tation with chalk or a felt-
tip pen before removing
❑ do not kink
❑ Routing of the ribbed V-
belt ⇒ page 39
❑ removing and installing
⇒ "1.2 Removing and in‐
stalling poly V-belt",
page 38
❑ pay attention to the cor‐
rect position on the belt
pulley when installing it.
2 - Screw
❑ replace after removal
❑ Use only original screws
⇒ ETKA - Electronic
Catalogue of Original
Parts
❑ 10 Nm + torque a further
1
90° ( / 4 turn)
3 - Crankshaft-belt pulley
❑ with vibration damper
❑ Fitting position: Bore in
the vibration damper
must be positioned
above the elevation on
the crankshaft toothed
belt pulley
❑ removing and installing
⇒ "1.3 Removing and in‐
stalling crankshaft-belt
pulley", page 40
4 - Tensioning device for V-ribbed belt
❑ removing and installing
5 - Screw
❑ replace after removal
❑ 20 Nm + torque a further 90° (
6 - Screw
❑ Tightening torque Pos. -2-
7 - Screw
❑ Tightening torque Pos. -12-
8 - Guide pulley
9 - Fitting sleeve
❑ pay attention to correct fit in the bracket for auxiliary units
10 - Bracket for auxiliary units
❑ removing and installing
11 - High pressure pump
❑ Summary of components
12 - Generator
❑ Summary of components ⇒ Electrical system; Rep. gr. 27
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ "1.4 Removing and installing tensioning device for V-ribbed belt", page 40
1
/ 4 turn)
⇒ "3.1 Summary of components - high pressure pump", page 338
⇒ Item 12 (page 44)
⇒ "1.5 Removing and installing bracket for auxiliary units", page 41
⇒ "3.1 Summary of components - high pressure pump", page 338
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Removing and installing a V-ribbed belt and a toothed belt
37