Skoda Octavia III 2013 Workshop Manual page 47

Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
Caution
When installing, risk of damage through reversing the rotation
direction of an already used V-ribbed belt.
♦ If the V-ribbed belt is re-installed, mark the direction of ro‐
tation with chalk or a felt-tip pen before removing it.
– To release the tension of the V-ribbed belt, use the ring span‐
ner to swivel the tensioning device anticlockwise -arrow-.
– Lock tensioning device with locking pin - T10060 A- .
– Remove poly V-belt.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– Lay the V-ribbed belt onto the V-ribbed belt pulleys:
1 - Crankshaft-belt pulley
2 - Tensioning roller
3 - Generator
4 - Air conditioner compressor
– Hold the tensioning element with the ring spanner and pull out
the locking pin - T10060 A- .
– Release pressure on tensioning device.
– Check correct positioning of the V-ribbed belt.
– Start engine and check ribbed V-belt run.
Tightening torques
♦ Sound dampening system - Summary of components ⇒ Body
Work; Rep. gr. 50 .
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Removing and installing a V-ribbed belt and a toothed belt
39