4.3
Removing and installing control motor
for exhaust gas recirculation - V338-
For vehicles with engine identification characters CRVC, CRKB,
CRMB, CUNA
Special tools and workshop equipment required
♦ Hose clamps up to ∅ 25 mm - MP7-602 (3094)-
Removing
Note
Observe rules for cleanliness.
– Remove throttle valve module - J338-
⇒ "6.2 Removing and installing the throttle valve control unit
J338 ", page 357
.
– Separate electrical plug connection -3-.
– Disconnect the coolant hose with the hose clamp -MP7-602
(3094)- .
– Loosen hose clamp -2-, remove coolant hose.
– Unscrew screws -arrows-, remove control motor for exhaust
gas recirculation - V338- .
Install
Install in the reverse order of removal. When doing this, note the
following:
Note
Replace gasket.
♦
Secure all hose connection ends with spring-type clips that
♦
comply with the series design ⇒ ETKA - Electronic Catalogue
of Original Parts .
Tightening torques
♦
⇒ "4.2 Control motor for exhaust gas recirculation V338 -
Summary of components", page 412
♦
⇒ "6.1 Assembly overview - intake manifold", page 355
4.4
Removing and installing control motor 2
for exhaust gas recirculation - V339-
For vehicles with engine identification characters CLHA, CLHB,
CRKB, CKFB, CKFC, CUPA, CRMB, CUNA
Special tools and workshop equipment required
♦ Hose clip pliers - VAS 6362-
Removing
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
4. Exhaust gas recirculation system
413