Skoda Octavia III 2013 Workshop Manual page 422

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– if a vacuum hose is present: Remove it -arrow- and lay to the
side.
– Press release buttons on the hose -1- for crankcase ventila‐
tion, remove hose from cylinder head cover.
– Disconnect vacuum hoses on the air guide pipe -arrows-.
– Loosen spring strap clip -3-, remove air guide pipe from air
mass meter - G70- .
– Release screw -2-, swivel air guide pipe with inlet connection
towards the rear and detach from exhaust gas turbocharger.
– Loosen spring strap clips -1-, -2-, remove exhaust gas recir‐
culation hose.
– Press heat protection sleeve to the side, disconnect electrical
plug connection -3-.
– Unscrew screws -arrows-, remove control motor 2 for exhaust
gas recirculation - V339- .
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Replace gasket and O-ring after disassembly.
♦
Secure all hose connections with spring-type clips that comply
♦
with the series design ⇒ ETKA - Electronic Catalogue of Orig‐
inal Parts .
Tightening torques
♦ ⇒ "4.1 Exhaust gas recirculation with radiator for exhaust gas
recirculation - Summary of components", page 408
♦ ⇒ "1.1 Exhaust gas turbocharger with component parts - Sum‐
mary of components", page 290
414
Rep. gr.26 - Exhaust system